Avidyne IFD540 Installation Manual page 156

IFD540 #1
3
SERIAL DME DATA
SERIAL DME CLOCK
SER DME-CHAN REQ/PAR DME-4MHZ
DME COMMON
SER DME-RNAV MODE/PAR DME-2MHZ
IFD540 #2
3
SERIAL DME DATA
SERIAL DME CLOCK
SER DME-CHAN REQ/PAR DME-4MHZ
DME COMMON
SER DME-RNAV MODE/PAR DME-2MHZ
NOTES:
1. ALL WIRES TO BE 24 AWG OR GREATER UNLESS OTHERWISE NOTED.
2. AT IFD540 UNIT, TERMINATE SHIELD GROUNDS TO THE CONNECTOR BACKSHELL OR USE CARD-EDGE CONNECTOR TO
TERMINATE SHIELD GROUNDS TO BACK PLATE – THE SHIELD LEADS MUST BE LESS THAN 3.0 INCHES. CONNECT OTHER
SHIELD GROUNDS TO AIRCRAFT CHASSIS WITH AS SHORT A CONDUCTOR AS PRACTICAL.
3. 3 THE IFD540 MUST BE CONFIGURED AT INSTALLATION TO OUTPUT KING SERIAL DME TUNING DATA UNDER THE DME CHANNEL
MODE.
REFER TO MANUFACTURER'S DOCUMENTATION FOR COMPLETE PINOUT AND INTERCONNECT INFORMATION. PINOUTS OF
4.
OTHER UNITS SHOWN FOR REFERENCE ONLY.
600-00299-000
IFD5XX Installation Manual
P1006
19
18
20
22
21 N/C
P1006
19
18
20
22
21 N/C
Figure D - 20: King Serial DME Tuning Interconnect, Panel Mount
Page 156 of 198
Bendix/King
KN 62/62A KN 64
P621/P62A1 P641
13 13
14 14
L L
NAV 1
C C
NAV 2
Revision: 02
DME
DATA BUS
CLOCK BUS
RNAV/CHANNEL REQUEST
DME COMMON