Avidyne IFD540 Installation Manual page 141

NOTES:
1. ALL WIRES TO BE 24 AWG OR GREATER UNLESS OTHERWISE NOTED.
2. AT IFD540 UNIT, TERMINATE SHIELD GROUNDS TO THE CONNECTOR BACKSHELL OR USE
CARD-EDGE CONNECTOR TO TERMINATE SHIELD GROUNDS TO BACK PLATE. THE SHIELD LEADS
MUST BE LESS THAN 3.0 INCHES. CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT CHASSIS
WITH AS SHORT A CONDUCTOR AS PRACTICAL.
3. 3 IF THE GPS ARINC 429 IN 1 PORT (P1001-48 AND -49) IS ALREADY USED FOR ANOTHER PURPOSE,
THE GPS ARINC 429 IN 2 PORT (P1001-50 AND -51) MAY BE CONNECTED INSTEAD.
4. REFER TO SECTION 7 FOR ARINC 429 CHANNEL SETTINGS.
5. REFER TO SECTION 7 FOR RS-232 CHANNEL SETTINGS.
REFER TO MANUFACTURER'S DOCUMENTATION FOR COMPELTE PINOUT AND INTERCONNECT
6.
INFORMATION. PINOUTS OF OTHER UNITS SHOWN FOR REFERENCE ONLY.
600-00299-000
Page 2 of 2
Page 141 of 198
IFD5XX Installation Manual
Revision: 02