Restoring A Certificate; Figure 4.11 [Confirmation Of Certificate] Window; Figure 4.12 [Replacement To The Previous Certificate] Window - Fujitsu Primequest 2000 Series Installation Manual

CHAPTER 4 REMCS Service Operations
4.2 REMCS Service Menu
2. Specify the certificate file and then click the [Next] button.
3. Confirm the display contents and, if they are acceptable, click the [Next] button.
If you do not intend to replace a certificate, click the [Cancel] button.
4. The following confirmation message is displayed."The certificates will be replaced. Once the replacement
of certificates proceeds, the report to the REMCS center will not be done until connected confirmation is
completed. Are you sure?"
If this is acceptable, click the [OK] button.
5. The machine status display becomes [UNUSED] and the [Connection check] window appears. Upon
confirmation, [ACTIVE] becomes effective.

4.2.9 Restoring a certificate

Use the following procedure to return to the previous certificate from the replacement certificate.
1. From the menu in the window shown in
previous certificate].
The window shown in

FIGURE 4.11 [Confirmation of certificate] window

FIGURE 4.12 [Replacement to the previous certificate] window

FIGURE 4.12 [Replacement to the previous certificate] window
FIGURE 4.1 [REMCS initial]
37
window, click [Replacement to the
appears.
CA92344-0542-02