Ce Certificate; Fcc Class A Compliance Statement - Fujitsu PRIMERGY RX100 S3 Operating Manual

CE Certificate

Other Important Notes:
When cleaning the device, please observe the relevant notes in the
"Cleaning the Server" on page
Keep this Operating Manual safety and all additional documentation
(e.g. Technical Manual, CD) together with the device. If you pass on the
device to third parties, you should also pass on the complete documentation.
3.2 CE Certificate
The shipped version of this device complies with the requirements
of the EEC directives 89/336/EEC "Electromagnetic compatibility"
and 73/23/EEC "Low voltage directive". The device therefore
qualifies for the CE certificate (CE=Communauté Européenne).
3.3

FCC Class A Compliance Statement

If there is an FCC statement on the device, then:
The following statement applies to the products covered in this manual, unless
otherwise specified herein. The statement for other products will appear in the
accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a
„Class A" digital device, pursuant to Part 15 of the FCC rules and meets all
requirements of the Canadian Interference-Causing Equipment Standard
ICES-003 for digital apparatus. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in strict accordance with the instructions, may cause harmful
interference to radio communications. However, there is no warranty that inter-
ference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
20
49.
Important Notes
section
U41615-J-Z156-1-76