Connection Check; Figure 4.13 [Connection Check] Window (Without Personal Information Deleted) - Fujitsu Primequest 2000 Series Installation Manual

CHAPTER 4 REMCS Service Operations
4.2 REMCS Service Menu
2. Confirm the content of the <<Restored certificate>> and then click the [Next] button.
If you do not wish to restore the certificate, click the [Cancel] button.
3. The following confirmation message appears. "The certificates will be replaced. Once the replacement of
certificates proceeds, the report to the REMCS center will not be done until connected confirmation is
completed. Are you sure?" If this is acceptable, click the [OK] button.
4.
The machine status becomes [UNUSED], and the [Connection check] window appears. Upon
confirmation, [ACTIVE] becomes effective.

4.2.10 Connection check

Use this menu item to check the connection to the REMCS Center.
1. From the menu in the window shown in
button.
The [Connection check] window (the window shown in
personal information deleted)
deleted) appears.
2.
Confirm the setting of the receivers of the connection results and click the [Check] button.

FIGURE 4.13 [Connection check] window (without personal information deleted)

FIGURE 4.1 [REMCS initial]
FIGURE 4.13 [Connection check] window (without
or FIGURE 4.14 [Connection check] window (with personal information
38
window, click the [Connection check]
CA92344-0542-02