Connection Type Change; Displaying The Certificate; Figure 4.6 Window For Changing The Active Connection Configuration; Figure 4.7 [Display Of Certificate] Window (With Certificate Not Replaced) - Fujitsu Primequest 2000 Series Installation Manual

CHAPTER 4 REMCS Service Operations
4.2 REMCS Service Menu

4.2.6 Connection type change

Use this menu item to change the current connection configuration to another configuration.
1. From the menu in the window shown in
change].
The [Connection type change] window (shown in
connection
2. After changing the connection configuration, click the [Next] button. The current setting information is
discarded and the machine status becomes [Setting not completed].
You need to perform the service start procedure by specifying the connection information again
according to

4.2.7 Displaying the certificate

Use the following procedure to confirm the information of the certificate.
1. From the menu in the window shown in
The window will appear according to following cases:
-

FIGURE 4.7 [Display of certificate] window (with certificate not replaced)

-

FIGURE 4.8 [Display of certificate] window (during use of certificate that has been replaced)

FIGURE 4.9 [Display of certificate] window (Certificate that has been displayed – previous certificate)
-
- Window displayed when the certificate has not been replaced
configuration) appears.
3.2.2 Setting the connection

FIGURE 4.6 Window for changing the active connection configuration

FIGURE 4.1 [REMCS initial]
FIGURE 4.6 Window for changing the active
configuration.
FIGURE 4.1 [REMCS initial]
34
window, click [Connection type
window, click [Display of certificate].
CA92344-0542-02