Table of Contents
Advertisement
A. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm) the
existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a DVP-HSM-B
will be required.
8 in.
Heat
(203 mm)
Shield
15-1/8 in.
(384 mm)
Max
12 in.
Effective
(305 mm)
Length
DVP-TRAP
Horizontal Termination Cap
DVP-TRAP2
DVP-TRAP1
DVP-TRAPK2
DVP-TRAPK1
DVP-HPC2
DVP-HPC1
Figure 12.2 DVP vent components
84
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
Advertisement
Table of Contents
