Table of Contents
Advertisement
RED60 Model With Media
This kit contains the components necessary to install the
granite on single sided RED60 models that have media
installed.
Kit Contents:
(3) Back panel pieces 19-13/16 inches wide x 16-7/8
inches tall. See Figure 1.
(2) Inner side wall pieces 10 inches wide x 16-7/8 inches
tall. See Figure 2.
(2) Outside corner trim pieces. See Figure 3.
(7) Securing tabs. See Figure 4.
(7) Sheet metal screws. See Figure 4.
16-7/8 IN.
19-13/16 IN.
Figure 1. Back Panel Pieces.
16-7/8 IN.
Figure 2. Inner Side Wall Pieces.
Figure 3. Outside Corner Trim Pieces.
Figure 4. Securing Tabs and Sheet Metal Screws.
10 IN.
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
Tools Required:
Cordless Drill
1/4 inch hex head driver tip
Pry Bar and Hammer for opening shipping crate.
Installation
1. Begin by removing back row and sides of quarter inch
sheet metal screws from base pan as shown in Figure 5.
The screws will be located either on top of or underneath
the mesh. If underneath mesh, lift mesh screen up and
remove for access to screw heads. After removing
screws replace mesh before installing granite.
Figure 5. Removing Screws from Basepan.
2. Measure granite to ensure you are installing the pieces
in the right orientation. Back panel pieces are to be
placed fi rst. These pieces are wider than they are tall.
Install so that width is 19-13/16 inches. Begin installing
pieces left to right. Place granite into fi rebox, bottom
side fi rst, then tilt top backward into position. Place the
fi rst piece on the left and move to right as you add the
other pieces. See Figure 6.
Figure 6. Placing Back Panel Piece.
3. Secure granite pieces using angle tabs and screws
provided. See Figure 7. Secure each piece as it is
placed into position to keep it from falling while placing
next piece into fi rebox. Continue with back middle piece
and then back right side.
19-13/16 IN.
79
Advertisement
Table of Contents
