Heat & Glo RED60 Installation Manual page 73

RED60 Model With Media
This kit contains the components necessary to install the
porcelain on RED60 models that have media installed.
Kit Contents:
(1) Inner back panel. See Figure 1.
(2) Inner side panels. See Figure 2.
(2) Outside corner trim pieces. See Figure 3.
(7) Angle tabs and (7) Sheet metal screws. See Figure 4.
Tools Required
Cordless Drill
1/4 inch hex head driver tip
Figure 1. Inner Back Panel.
Figure 2. Inner Side Panels.
Figure 3. Outside Corner Trim Pieces.
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
Figure 4. Angle Tabs with Screws.
Installation
1. Verify the correct base pan is in the appliance before
proceeding with the porcelain installation. The base pan
required for this application has the letter "M" stamped
in it. See Figure 5. If the base pan does not have the
letter "M" stamped in it, contact your dealer.
M
Figure 5. Base Pan
2. Begin by placing back panel. Place bottom in fi rst and
tilt top backward carefully until it touches the back wall.
Secure with angle tabs and screws in the three pilot
holes that are located on the top of the fi rebox.
Figure 6. Installing Angle Tab to Secure Inner Back Panel.
3. Using a fl at blade screwdriver, bend up the tabs located
on each side of the basepan to a 90 degree angle. See
Figure 7.
4. Slide each inner side porcelain panel in from the front
until it touches the back wall. Secure with angle tabs
and screws in the pilot holes that are located on the top
of the fi rebox. See Figure 6.
5. Bend the tabs mentioned on step 3 toward the porcelain
panel. See Figure 8.
73