Heat & Glo RED60 Installation Manual page 77

Figure 11. Installing First Back Panel Granite Piece.
4. Secure granite pieces into place using the angle tabs
and screws provided. See Figure 12. Begin with the
back left piece and follow with the back middle and then
back right side piece.
Figure 12. Fastening Angle Tabs to Secure Granite in Place.
5. Slide side pieces into place from the front and hold in
place while installing the angle tabs and screws provided.
The correct orientation for the side pieces is 10 inches
wide by 16-7/8 inches high. Use retaining tabs, one on
each side, to secure each side piece. See Figure 13.
6. Place rear base mesh granite support pieces between
burner rail and back of appliance with the bent sides
down. They will sit securely on the base pan. Ensure
you are placing the mesh piece that does NOT have
notches. See Figure 14.
10 IN.
Figure 13. View of Back and Side Pieces Installed.
19-13/16 IN.
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
7. Place notched front base mesh granite support pieces
between burner rail and front of appliance. The notched
area of the granite support piece will be positioned over
the pilot area and will sit securely on the base pan.
Proper placement of mesh around pilot is critical to safe
operation.
WARNING
Delayed Ignition Risk
Place mesh piece with notch on area around pilot.
DO NOT place mesh piece without notch over
pilot. Interruption of pilot fl ame will occur.
Fireplace will not function properly.
Delayed ignition may occur.
Figure 14. Installing Front Base Mesh Granite Support.
Figure 15. Base Mesh Installed.
8. Install the three rear base granite pieces by placing
them, one at a time, into position and centering them
front to back. The gap between the front edge of the
granite pieces and the burner area and between the
back edge of the granite pieces and the rear wall should
be equal.
9. Install the three inner front base pieces by placing them,
one at a time, into position and centering them front
to back. There will be a gap between the edge of the
granite pieces and the burner area. See Figure 16. The
correct orientation for the front pieces is 19-3/8 inches
wide by 4-5/8 inches deep.
NOTCHED AREA
OVER PILOT
77