Table of Contents
Advertisement
Figure 7. Fastening Angle Tabs to Secure Granite in Place.
4. Slide side pieces into place from the front and hold in
place while installing the angle tabs and screws pro-
vided. Measure to be sure that the pieces are placed
in the correct orientation. For the side pieces, the width
is the 10 inch dimension.
10 IN.
Figure 8. View of Back and Side Piece Installed.
5. Install glass rocks in base of fi rebox according to glass
media installation instructions. Install glass frame as-
sembly and spring lock into place.
WARNING
Delayed Ignition Risk
• Place rock media according to instructions.
• Do NOT place rock media in area in front of pilot
or between burner tracks.
• Do NOT place rock media in a position that they
may fall into area in front of pilot.
• Do NOT use any media other than what is
supplied with this fi replace.
• Do NOT use more than three 10 lb. bags of rock
media per fi replace.
• Do NOT use more than fi ve bags of media in the
fi replace (when applicable).
Fireplace will not function properly.
Delayed ignition may occur.
6. Install front media tray. Do not place glass rock media
at this time.
7. Install outer corner granite trim pieces. Slowly slide
into position as shown in picture. Use securing tabs to
hold in place. Tabs attach at the top using sheet metal
screws and pilot holes located above the granite. See
Figure 9 and Figure 10.
80
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
GLASS FRAME TAB
RETAINING TAB
Figure 9. Attaching Retaining Tab to Glass Frame Tab.
RETAINING TAB CONTACTS GRANITE
Figure 10. Placing Outer Corner Granite Trim Piece.
8. Place glass rock media in front media tray according
to glass media installation instructions.
2
3
1
ITEM
DESCRIPTION
Refractory Kit
1
Side Panel (Qty 2 req)
2
Panel Side (Qty 2 req)
3
Back Panel (Qty 3 req)
Figure 11. Service Parts Diagram.
3
3
2
1
PART NUMBER
GR60-L
2159-211
2159-210
2159-209
Advertisement
Table of Contents
