Heat & Glo RED60 Installation Manual page 74

BEND TAB UP BEND TAB UP
Figure 7. Bend Tabs Up to a 90 Degree Angle.
Figure 8. Bend Tabs Toward Panel
6. Install glass rocks in base of fi rebox according to glass
media installation instructions.
7. Install glass frame assembly according to instructions
in installation manual.
8. Install front media tray.
9. Install four retainer clips (included) as shown in Figure
9. Outside corner trim piece will be forced into clip on
front of fi replace. See Figure 10 and Figure 11.
CLIP
CORNER TRIM
FORCED BETWEEN
SURFACES
Figure 9. Clip Location.
74
TAB BENT TO TAB BENT TO
90º ANGLE 90º ANGLE
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
Figure 10. Installing Outside Corner Trim Piece onto Clip.
Figure 11. Installing Outside Corner Trim Piece onto Clip.
WARNING
Delayed Ignition Risk
• Place glass rock according to instructions.
• Do NOT place glass rock in area in front of pilot
or between burner tracks.
• Do NOT place glass rock in a position that they
may fall into area in front of pilot.
• Do NOT use any media other than what is
supplied with this fi replace.
• Do NOT use more than three 10 lb. bags of glass
rock per fi replace (when applicable).
• Do NOT use more than fi ve bags of media in the
fi replace (when applicable).
Fireplace will not function properly.
Delayed ignition may occur.
CLIP CLIP