Heat & Glo RED60 Installation Manual page 71

Installation and appliance setup
Hide thumbs Also See for RED60:
Table of Contents

Advertisement

Installation
1. Verify the correct base pan is in the appliance before
proceeding with the porcelain installation. The base
pan required for this application has the letters "NNN"
and "NNP" stamped in it. See Figure 8. If the base
pan does not have these letters stamped in it, contact
your dealer.
NNN
Figure 8. Location of Base Pan Identifi cation
2. Begin by placing the back panel into the fi rebox, bottom
side fi rst, then tilt top backward into position. Secure
with angle tabs and screws in the three pilot holes that
are located on the top of the fi rebox. See Figure 9.
3. Place each side panel into fi rebox, bottom side fi rst,
then tilt top backward into position. Secure with angle
tabs and screws in the pilot holes that have are located
on the top of the fi rebox. See Figure 10.
Figure 9. Fastening Angle Tab to Secure Inner Back Panel.
Figure 10. Fastening Angle Tab to Secure Inner Side Panel.
NNP
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
4. Place rear inside porcelain base piece. Place into bot-
tom of fi replace with tabs away from the burner. Center
from front to back. There will be a gap between the front
edge of the base piece and the burner area and also
a gap between the back of the porcelain piece and the
rear porcelain panel. These two gaps should be equal.
See Figure 11.
5. Install front inside porcelain base piece. Position into
bottom of fi replace with tabs facing the outside edge of
the fi rebox. Center from front to back. There will be a
gap between the front edge of the base piece and the
front of the fi rebox and also a gap between the back
of the porcelain piece and the burner rail. These two
gaps should be equal. See Figure 11.
Figure 11. Placing Porcelain Base Pieces.
6. Install glass frame assembly and spring lock into posi-
tion. Set front porcelain trim shelf into position.
7. Position trim shelf so tabs are facing the glass assem-
bly. Insert into glass frame. See Figure 12.
GLASS ASSEMBLY
TABS FACE GLASS
ASSEMBLY
Figure 12. Positioning Porcelain Access Panel.
GLASS ASSEMBLY
ACCESS PANEL
Figure 13. Porcelain Trim Shelf Installed.
TABS
71

Advertisement

Table of Contents
loading

Table of Contents