Heat & Glo RED60 Installation Manual page 76

Figure 4. Securing Tabs and Sheet Metal Screws.
19-3/8 IN.
Figure 5. Inner Front Base Pieces.
19-3/8 IN.
Figure 6. Inner Rear Base Pieces.
Figure 7. Outside Front Trim Base.
REAR BASE MESH GRANITE SUPPORT
FRONT BASE MESH GRANITE SUPPORT
Figure 8. Middle and Outer Base Pan Granite Support Tabs.
76
4-5/8 IN.
3-3/4 IN.
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
Installation
1. Ensure fi replace is turned off and glass is cool to the
touch before beginning installation. .Remove back row
and sides of 1/4 inch sheet metal screws from base
pan as shown in Figure 9. The screws will be located
either on top of or underneath the mesh. If underneath
mesh, lift mesh screen up and remove for access to
screw heads. Discard mesh.
2. Remove pilot shield as shown in Figure 10. Discard.
Figure 9. Removing Screws from Basepan.
3. Measure granite pieces to ensure you are installing them
in the correct orientation. Install back panel pieces fi rst.
See Figure 11. These pieces are wider than they are
tall. Install so the side measuring 19-13/16 inches is
the width. Pieces should be installed left to right. Place
granite into fi rebox, bottom side fi rst. Tilt the top away
from you, placing it into position. Secure each piece
individually as it is placed into position to keep it from
falling while the next piece is placed.
PILOT
SHIELD
Figure 10. Removing Pilot Shield.