Heat & Glo RED60 Installation Manual page 53

Optional Confi guration Requirements
• This appliance ships standard with a wall switch.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
The junction box, control module, power vent power sup-
ply and LED power supply can be accessed thru the air
space between the fi rebox front and the lower-front fi nish-
ing cover panel. The decorative front and glass assem-
bly must be removed to access these components. See
Figure 8.3.
Note: If the fan is moved from one side to the other, the valve,
all electrical components, including the thermodiscs, must
also be moved to the opposite side of the appliance. See
appropriate confi guration in relation to the valve in Figures
8.4 and 8.5. In addition, two jumper wires will be required
between the two 107-559a wire harnesses that plug into
the junction box. These wires must be 24 inches in length,
made from 14 gauge AWG wire (or equivalent), have a 1/4
inch male insulated terminal at each end and be made by a
licensed electrician following all local electrical codes.
A battery back up is not compatible with the RED60 and
may not be installed.
FAN ASSEMBLY FAN ASSEMBLY
Figure 8.3 Valve Cavity (Lower Access Panel Removed)
MODULE MODULE
THERMODISC THERMODISC
Figure 8.4 Valve Cavity
JUNCTION BOX JUNCTION BOX
VALVE VALVE
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
FAN
INSTALLED ON
LEFT
JUNCTION
BOX
AUX300
8K1-PVI
LED POWER SUPPLY
(IF EQUIPPED)
THERMODISCS
LED POWER SUPPLY
VALVE
Figure 8.5 Controls Location Diagram
THERMODISCS
VALVE
BRACKET
VALVE
FAN
INSTALLED ON
RIGHT
JUNCTION
BOX
AUX300
8K1-PVI
(IF EQUIPPED)
53