26.
Re-install the Developer Frame Assembly, the HVPS, and Door C.
Replacement Note
Match the colors of the 4 toner nozzles to the correct positions on the
Developer Frame Assembly before attaching them.
Before reinserting the pins for Door C, verify that the shoulders on the end of
each pin faces out and the bosses on the Developer Frame Assembly guides
are set in the notches provided in Door C.
27.
Remove 4 screws (self-tapping, plastic 10 mm) that secure the Registration
Roller.
Note
Observe the wire routing between the Registration Roller and Engine Control
Board. Route the wires in the same manner upon re-installation.
28.
Disconnect the two connectors connected to Registration Chute.
29.
Move the Registration Roller Assembly to the left and lift it up to remove.
Cleaning and Maintenance
s6300-159
7-13