Restore Factory Margins Settings
You can reset margin settings to the factory-default values.
Caution
Use caution when resetting your margins to the factory-default settings.
Changing these settings back to factory defaults may not be the last-saved
settings if you have previously calibrated your margins.
1.
On the Control Panel, select Troubleshooting, and then press the OK button.
2.
Select
Print Quality Problems
3.
Select
Calibrate Margins
4.
Select
Restore Factory
margin settings.
Resetting Connection Setup Defaults
Resetting the Connection Setup values sets TCP/IP address, TCP/IP address menu
settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk, Netware, set IPX frame
type, IPP, Ethernet speed, Wait Timeout, Page Description Language, and USB Port
selection to their default values.
Caution
Make note of the current network settings or print a Configuration page to
provide a record of the customer's current network settings before resetting the
connection setup to the factory default values.
1.
On the Control Panel, select
2.
Connection
Select
3.
Reset Connection
Select
connection defaults.
Resetting Paper Handling Defaults
Resetting the Paper Handling defaults resets the paper source, 2-sided printing, tray
setup, load paper timeout, tray sequence, custom units and jam recovery settings to
their default values.
1.
On the Control Panel, select
2.
Select
Paper Handling
3.
Select
Reset Paper Handling
4.
Select
Reset Paper Handling Setup
reset the paper handling defaults.
Adjustments and Calibrations
menu, and then press the OK button.
menu, and then press the OK button.
Settings, and then press the OK button to reset the
Printer
Setup, and then press the OK button.
Setup, and then press the OK button.
Setup, and then press the OK button to reset
Printer
Setup, and then press the OK button.
Setup, and then press the OK button.
Setup, and then press the OK button.
NOW, and then press the OK button to
6-5