Xerox Phaser 6300 Service Manual page 536

Service Diagnostics Tests and Utilities (Continued)
Test
Tray 1 (MPT) No
Paper Sensor
Tray [2] [3] [4] [5] No
Paper Sensor
Transfer Roller
Toner Full Sensor
Image Unit Not
Installed Sensor
Fuser Fan Rotation
Sensor
Rear Fan Rotation
Sensor
CTD (ADC) Sensor
Fuser NC Sensor
Fuser STS Sensor
Fuser NC Sensor
Amplifier
Fuser Temp
Compensation
Main Motor Rotation
Sensor
Developer Motor
Rotation Sensor
Fuser Motor
Rotation Sensor
Reference
Control Panel Display and Test Definition
Paper is Not Present
Paper is Present
Paper is Not Present
Paper is Present
Toner Waste [Not] Full
Image Unit is [Not] Present
Fuser Fan Rotation Sensor is:
OK
Failure
Rear Fan Rotation Sensor is:
OK
Failure
Dark Value: #
Light Value: ###
Sensor OK
<Fuser NC Sensor>
Fuser (Not) Ready
Sensor (Failure) is OK
<Fuser STS Sensor>
Fuser (Not) Ready
Sensor (Failure) is OK
<Fuser NC Sensor Amplifier>
Fuser (Not) Ready
Temperature Amplifier (Failure) is
OK
<Fuser Temp Compensation>
Fuser (Not) Ready
Compensation (Failure) is OK
Main Motor Rotation Sensor is:
OK
Failure
Developer Motor Rotation Sensor is:
OK
Failure
Fuser Motor Rotation Sensor is:
OK
Failure
Move the Tray 1 No Paper Actuator
(PL5.3.15) to change sensor state.
Insert Tray [2] [3] [4] [5] with an
adequate amount of paper.
Toggle the No Paper Actuator.
Block the Toner Full Sensor
(PL5.2.20) to change the sensor
state.
Open Door C to change the state
of the Switch.
Status only
Status only
Status only
Remove the Transfer Roller to
observe change of state.
Remove Fuser to change sensor
state.
Remove Fuser to change sensor
state.
Remove Fuser to change sensor
state.
Remove Fuser to change sensor
state.
Status only
Status only
Status only
A-15