Generalmusic WK3 World Keyboard Owner's Manual page 218

1/3 BRILLIANCE (F5, F6)
Affects the Brilliance of the sounds, causing an
increase in the brightness or rendering the sound
more mellow.
Use the standard Drumkit edit procedure.
1/3 SOUND EDIT:STAND1 [BRILLIANCE]
Vol=12 Vel=7
SOUND EDIT: Stand1 [Brilliance]
Assignable values: 0 . .. 127
Press ESCAPE to return to the previous page,
or SOUND to exit Edit Sound.
Press STORE PERF + ENTER to store the modi-
fications to the current Performance.
1/3 TUNE (F7, F8)
A high resolution fine tune parameter.
Fine tine a percussive sound to render the sound
more natural.
Use the standard Drumkit edit procedure.
1/3 SOUND EDIT:STAND1 [TUNE]
Vol=12 Vel=7
SOUND EDIT: Stand1 [Tune]
Assignable values: 0 . .. 255
Press ESCAPE to return to the previous page,
or SOUND to exit Edit Sound.
Press STORE PERF + ENTER to store the modi-
fications to the current Performance.
2/3 PAN (F1, F2)
Press PAGE+ to enter level 2.
Determines the position of the percussive sound
within the stereo panorama.
Move the sound to the left (L), to the right (R), set
it to the centre (C) or mute the sound (Mute).
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
13•32 Reference Guide
E C4
Bril=127 Tune=150
E C4
Bril=127 Tune=150
○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Use the standard Drumkit edit procedure.
1/3 SOUND EDIT:STAND1 [PAN]
Pan=R15
SOUND EDIT: Stand1 [Pan]
Assignable values: L31 (all to the left) ... 00 (cen-
tre) ... R31 (all to the right), Mute .
Press ESCAPE to return to the previous page,
or SOUND to exit Edit Sound.
Press STORE PERF + ENTER to store the modi-
fications to the current Performance.
2/3 REVERB (F3, F4)
Reverb send which controls the amount of Reverb
applied to the percussive sound. The Reverb
applied corresponds to the type currently selected
in the Reverbs DSP.
Zero level corresponds to the pure percussive
sound (Dry).
Increasing the parameter value increases the
amount of Reverb applied, altering the Wet/Dry
ratio until the percussive sound is fully effected
(Wet).
Check that the Reverbs button in the DSP sec-
tion is active (led on) to hear the changes ap-
plied to the parameter.
Use the standard Drumkit edit procedure.
1/3 SOUND EDIT:STAND1 [REVERB]
Pan=R15
SOUND EDIT: Stand1 [Reverb]
Assignable values: 0 ... 15 .
Press ESCAPE to return to the previous page,
or SOUND to exit Edit Sound.
Press STORE PERF + ENTER to store the modi-
fications to the current Performance.
○ ○
Rev=7 Eff=0
Rev=7 Eff=0
E C4
E C4