Led Indications - Planet XGSW-28040HP User Manual

■ Reset button
At the right of the front panel, the reset button is designed for rebooting the Managed Switch without turning off and on the
power. The following is the summary table of reset button
Reset Button Pressed and Released
< 5 sec: System Reboot
> 5 sec: Factory Default

2.1.2 LED Indications

The front panel LEDs indicate instant status of power and system status, fan status, port links / PoE in-use and data activity;
they help monitor and troubleshoot when needed.
XGSW-28040HP LED Indication
XGSW-28040HP LED Indication Table
 LED definition

System
LED Color
SYS Green
PWR Green
Green
Ring
Green
R.O.

Alert
LED Color
FAN1~2 Green
PWR1~2 Green
Function
Reboot the Managed Switch.
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as shown below:
。
。
。
。
。
Figure 2-1-2
Figure 2-1-2: XGSW-28040HP LED at Front Panel
Lights to indicate the system is working.
Lights to indicate that the Switch has power.
Indicates that ring state is in idle.
Lights
Indicates that ring state is in protected.
Blink
Indicates that the switch is set to ring owner.
Lights
Indicates that the switch doesn't set to ring owner.
Off
Lights to indicate fan1~2 failure.
Lights to indicate power1~2 failure.
User's Manual of XGSW-28040HP
functions:
Default Username: admin
Default Password: admin
Default IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.254
shows the LED indications of the Managed Switch.
Function
Function
23