Table of Contents
Advertisement
Figure 4-6-14: Changes Port VLAN of Port 1~3 to be VLAN2 and Port VLAN of Port 4~6 to be VLAN3
For the VLAN ports connecting to the hosts, please refer to 4.6.10.1 examples. The following steps will focus on the VLAN
Trunk port configuration.
1.
Specify Port-7 to be the 802.1Q VLAN Trunk port.
2.
Assign Port-7 to both VLAN 2 and VLAN 3 at the VLAN Member configuration Page.
3.
Define a VLAN 1 as a "Public Area" that overlapping with both VLAN 2 members and VLAN 3 members.
4.
Assign the VLAN Trunk Port to be the member of each VLAN – which wants to be aggregated. For this example, add Port-7
to be VLAN 2 and VLAN 3 member port.
5.
Specify Port-7 to be the 802.1Q VLAN Trunk port, and the Trunking port must be a Tagged port while egress. The Port-7
configuration is shown in
Figure 4-6-15: VLAN Overlap Port Setting & VLAN 1 – The Public Area Member Assign
That is, although the VLAN 2 members: Port-1 to Port-3 and VLAN 3 members: Port-4 to Port-6 also belongs to VLAN 1. But
with different PVID settings, packets form VLAN 2 or VLAN 3 is not able to access to the other VLAN.
Figure 4-6-15.
User's Manual of XGSW-28040HP
122
Advertisement
Table of Contents
