Configuration; Programming With The Keypad; Text Keypad Programming - Bosch AMAX 2100 Installation Manual

AMAX 2100 / 3000 / 4000
8

Configuration

This chapter describes how to configure the settings of the AMAX panel. The settings can be
configured either via a text keypad or via the PC software A-Link Plus.
For detailed description of the possible settings please refer to Settings, page 32.
8.1

Programming with the Keypad

8.1.1

Text Keypad Programming

Access to the Menus
Accessing the Programming Menu
1.
2.
3.
P
P
Accessing the User Menu
4
P
P
Navigation of the Menus
This section provides an overview of how to navigate the programming menu of a text keypad.
Selecting a Menu
1.
2.
3.
Exiting a Menu
4
Confirming the Input
4
Switching between Settings
4
Operating a Menu
1.
2.
Exiting the Programming Menu
1.
2.
It is optional to save or not to save the programming data.
1.
2.
Bosch Sicherheitsysteme GmbH
Confirm that the system is disarmed.
Enter the installer code. The default setting for the installer code is [1234].
The system displays [958] PROGR. MODE [-EXIT].
Enter [958] + press [#].
You have now access to the programming menu for configuring the AMAX system.
The STAY and AWAY indicators flash to indicate the programming mode.
Enter the user code. The default setting for the user code is [2580].
The system displays [▼/▲] USER MENU *STAY #AWAY [-] INFO.
You have now access to the user menu for operating the AMAX system.
Select the menu and operate according to the menu prompt.
Press [▼] or [▲] to navigate to the desired menu.
Press [#] to enter a menu.
Press [–] to get back to the previous menu.
Press [#] to confirm the input.
Press and hold [*] for 3 seconds to switch between settings.
Operate according to the menu prompt.
Select the menu and enter data for specific programming items according to the display
on the keypad to complete the programming, step by step.
Press [#] to confirm each step.
Complete all programming input by repeating the programming steps above and press [–]
to get back to the current main menu level by level.
Press [–] to get to the EXIT PROG. +SAVE menu.
Select EXIT PROG. +SAVE and press [#] to save the data and to exit the programming
mode.
Select EXIT PROG. UNSAVED and press [#] to exit programming mode without saving
the data.
Installation Guide
Configuration | en 81
2014.11 | 02 | F.01U.267.112