B450 With B442; General; Address Setting; Wiring - Bosch AMAX 2100 Installation Manual

AMAX 2100 / 3000 / 4000
5.6

B450 with B442

5.6.1

General

Use B450 in combination with a plug-in communicator for primary or backup alarm
communication, remote panel programming and other remote applications. The B450 supports
Conettix IP protocol with full authentication, 256 bit AES encryption and resistance to Denial
of Service attacks. It is a reliable way to add cellular network communications to existing or
new commercial security and fire installations.
For the AMAX panel B450 is used in combination with B442, which provides IP communication
over a GSM (GPRS) cellular network.
Installation
1.
2.
3.
4.
P
5.6.2

Address Setting

Set the rotary switch to 6 which corresponds to option bus address 134.
5.6.3

Wiring

The following graphic shows how to wire B450 to the option bus of the AMAX panel.
AMAX 4000
Figure 5.8: Wiring of B450 with an AMAX panel
5.6.4

Status Indicator

B450 and B442 provide several LED indicators. The following table describes the heartbeat
LED indicator of B450 and the status LED indicator of B442 (blue).
Bosch Sicherheitsysteme GmbH
Disconnect all power supplies of the AMAX panel before installing B450.
Use the standard three-hole installation mode to install B450 in the enclosure of the
AMAX panel or another enclosure. For more information refer to Module Installation, page
25 and to B450 Conettix Plug-in Communicator Interface.
Instert SIM card into B442.
Insert B442 into B50.
B442 clicks and the module combination is ready to be wired.
AMAX 2100 / 3000
Optional Modules and Peripheral Devices | en
Installation Guide
21
B450
2014.11 | 02 | F.01U.267.112