78
en | Settings
7.6.2
Sirens
Alarm Siren Ringing Time
The alarm siren ringing time is valid only when the keypad alarm tone is enabled. When an
audio alarm occurs in the system, the alarm siren begins to ring. After a valid arming /
disarming command, an alarm reset or after the alarm siren ringing duration ends, the alarm
siren stops ringing.
For programming of alarm time, refer to Output Programming, page 132.
Beep For Warning Devices
Enables / disables beep for warning devices when the system is armed, disarmed, or during
walk test.
Internal Siren Beep as Indication
Enables / disables internal siren beep as indication when the system is armed, disarmed, or
programming mode is entered.
Silence Warning Device When Disarmed
Enables / disables silence warning device when disarmed or by pressing any key.
7.7
RF Devices
7.7.1
RF Options
RF Receiver Functionality
Enables or disables RF receiver functionality.
RF Supervision Interval
Disables or defines RF Supervision Interval. The interval can be set to 1, 2, 4, 12, 24, or 25
hours.
RF Jam Detect Level
Defines RF jam detect level. The range is from 0 to 15 where 0 is most sensitive.
RF Device Low Level Battery Resound
Disables or sets the interval for keypad acoustic indication of RF device low level battery fault.
Siren Beep Arm / Disarm (RF Keyfob)
Enables or disables keypad acoustic indication on arm / disarm.
Keyfob Panic Option
Defines the behavior when keyfob panic button is pressed. The option can be set to no alarm,
silent alarm, or non silent alarm.
7.7.2
RF Devices / User
RF User
Keyfobs are designed for arming and disarming the system remotely, trigger a panic alarm, or
for additional control functionality.
To operate the buttons, press and hold either button for at least one sec in order to use the
desired feature.
The AMAX panel identifies keyfob users by device RFID. AMAX Keypad programming supports
entering RFID automatically for Radion devices.
2014.11 | 02 | F.01U.267.112
Installation Guide
AMAX 2100 / 3000 / 4000
Bosch Sicherheitsysteme GmbH