Bosch AMAX 2100 Installation Manual page 150

150 en | Troubleshooting
2.
P
–
Condition:
A disassembly of DX2010 module 1, 2, 3, 4, 5, or 6 is detected and the occurrence of zone
extension module 1, 2, 3, 4, 5 or 6 is considered as a tamper condition.
Restore:
4
Supervise:
1.
2.
P
–
Condition:
Tamper contact is triggered (if the corresponding zone is programmed as DEOL).
Restore:
4
Supervise:
1.
2.
P
–
Condition:
Tamper contact (directly connected to the zone) is triggered (zone type = tamper).
Restore:
4
Supervise:
1.
2.
P
–
Condition:
2014.11 | 02 | F.01U.267.112
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the tamper condition is reset, send the restored report to the configured
destinations.
The FAULT indicator is turned off when there is no other system fault.
Zone Expansion Module 1-6 Tamper
Restore the DX2010 module 1, 2, 3, 4, 5, or 6 to a normal condition and reset the fault.
For more information, refer to DX2010, page 16.
Report the tamper condition to configured destination on address 0124 when the tamper
condition is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the tamper condition is reset, send the restored report to the configured
destinations.
The FAULT indicator is turned off when there is no other system fault.
Zone Tamper 1-16 DEOL
Restore the tamper contact and reset the tamper condition.
Report the sensor tamper to configured destination on address 124 when the sensor
tamper is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the tamper condition is reset, send the restored report to the configured
destinations.
The FAULT indicator is turned off when there is no other system fault.
Zone type 1-16 Tamper
Restore the tamper contact and reset the tamper condition.
Report the tamper condition to configured destination on address 124 when the tamper
condition is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 10 for a detailed description).
When the tamper condition is reset, send the restored report to the configured
destinations.
The FAULT indicator is turned off when there is no other system fault.
Keypad Lock out
Installation Guide
AMAX 2100 / 3000 / 4000
Bosch Sicherheitsysteme GmbH