Bosch AMAX 2100 Installation Manual page 75

AMAX 2100 / 3000 / 4000
The output is reset in the following cases:
–
–
If the output time is set to 000, the output will continue until the telephone line is restored
and the fault is reset.
11 - AC Power Supply Fault
This output is operated when an AC power fault occurs.
The output is reset in the following cases:
–
–
If the output time is set to 000, the output will continue until the AC power supply is restored
and the fault is reset.
12 – Battery fault
This output is operated when a low battery fault occurs.
The dynamic battery test is performed every four hours after the system is powered up and
every time the system is armed.
The output is reset in the following cases:
–
–
If the output time is set to 000, the output will continue until the battery is restored and the
fault is reset.
13 - Tamper
This output is operated when a tamper occurs.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the tamper condition is restored
and the tamper is reset.
14 - External Fault
This output is operated when an external fault occurs.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the external fault is restored and
the fault is reset.
15 - All Faults
This output is operated when a fault occurs.
The output is reset when the programmed output time ends.
If the output time is set to 000, the output will continue until the fault is restored and the fault
is reset.
16 - Fire Alarm
This output is operated when a fire alarm occurs.
17 - Fire Reset
This output is operated when a fire alarm is reset.
Bosch Sicherheitsysteme GmbH
The telephone line is restored and the fault is reset.
The programmed output time ends.
The AC power supply is restored and the fault is reset.
The programmed output time ends.
A dynamic battery test reports that the backup battery voltage is normal and the fault is
reset.
The programmed output time ends.
Installation Guide
Settings | en 75
2014.11 | 02 | F.01U.267.112