Wiring; Status Indicator; B426; General - Bosch AMAX 2100 Installation Manual

AMAX 2100 / 3000 / 4000
5.4.3

Wiring

The following table and graphic show how to wire DX3010 to the option bus of the AMAX
panel.
Power Supply
AMAX panel
External power supply
Table 5.9: Lengths of cable for DX3010
AMAX 2100 / 3000
AMAX 4000
Figure 5.6: Connecting DX3010 to the AMAX Panel
5.4.4

Status Indicator

None.
5.5

B426

5.5.1

General

AMAX panel supports up to two communication modules:
–
–
The B426 Ethernet communication module supports monitored two-way IP communication via
Ethernet to perform alarm transmission, remote programming, and control of the AMAX panel.
Installation
1.
2.
3.
5.5.2

Address Setting

Set the rotary switch to 6 which corresponds to option bus address 134 for the first B426.
Set the rotary switch to 9 which corresponds to option bus address 250 for the second B426.
Bosch Sicherheitsysteme GmbH
ITS-DX4020-G and B426 or
B426 and B426
Disconnect all power supplies of the AMAX panel before installing B426.
Use the standard three-hole installation mode to install B426 in the enclosure of the
AMAX panel or another enclosure. For more information refer to Module Installation, page
25 and to B426 Ethernet Communication Module.
Use network or direct connection to access the built-in web server when reconfiguring
the module or when connecting the module to the AMAX panel with RPS.
Optional Modules and Peripheral Devices | en
Wire diameter of 0.8mm
12.2m
305m
DX3010
Installation Guide
Wire diameter of 1.2mm
24.4m
610m
DX3010
_
+
12V
2014.11 | 02 | F.01U.267.112
19