Arming In Stay Mode; Forced Arming; Disarming The System; Disarming With Code - Bosch AMAX 2100 User Manual

AMAX
2.1.2

Arming in STAY Mode

STAY Mode is used when you need to arm the perimeter and unused areas of the premises to
detect a would-be intruder, while at the same time being able to move freely within an area
that is automatically isolated.
There are two methods to arm your system in STAY mode.
Method 1:
To arm the system in STAY mode enter your code and press [*].
It beeps twice, the STAY indicator flashes slow and exit time starts. After exit time, the
STAY indicator is on.
The lights corresponding to all zones programmed as automatically isolated zones (Interior
Instant Zone) begin to flash and continue until the exit time is finished.
Method 2:
To arm the system in STAY mode press and hold [*] for 3 seconds.
When it beeps twice, release the button.
The STAY indicator flashes slow and exit time starts. After exit time, the STAY indicator is on.
Please contact your installer to enable/disable this function.
2.1.3

Forced Arming

Arming the system when a zone is not sealed is known as forced arming.
If the AWAY indicator is not on and a long beep sounds when you attempt to arm the system in
AWAY mode, then forced arming is not permitted. If this is the case, you will have to seal all
zones or manually isolate them before you can arm the system.
Please contact your installer to enable/disable this function.
2.2

Disarming the System

2.2.1

Disarming with Code

Enter your code and press [#] .It beeps twice and the AWAY or STAY indicator is extinguished.
2.2.2

Disarming with Key Switch

When the Key switch is deactivated, the system is disarmed and the AWAY or STAY indicator is
extinguished.
Bosch Sicherheitsysteme GmbH User Guide
Arming and Disarming the System | en
2014.01 | 02 | F.01U.295.569
11