Installation Of The Attachment Stand - Pioneer PDP-425CMX Technical Manual

Installation of the Attachment Stand

4.3 Installation of the Attachment Stand
Be sure to fix the supplied stands to the installation surface.
Use commercially available M8 bolts that are 25 mm
longer than the thickness of the installation surface.
1.
Fix the supplied stands to the installation surface at
each of the 4 prepared holes using commercially
available M8 bolts.
Front
Rear
110 mm
Always install the supplied display stands
according to the dimensions shown in
the accompanying illustration.
2.
Insert the unit into the stand.
50
517 mm
(Bolt hole thread pitch)
3.
Tighten the bolt against the washer so as to secure
the unit.
The unit weights 30 kg. or more, and its
thinness makes it unstable. Therefore, it
CAUTION
should be unpacked, carried and installed
by two or more persons.
Use a 6 mm hexagonal
wrench to tighten the bolt.