Pioneer PDP-425CMX Technical Manual page 67

2 Place the PDP side hardware on the spacers with
its holes aligned.
Top side of plasma display
4 With the plasma display separated from the PDP side
hardware by spacers, fix the plasma display to the
hardware with bolt M8 (4 locations).
Use the hole marked with a red "%" as the standard.
If the angle of incline is increased, the top of the angle
adjustment use screw may be visible from a horizon-
tal position on the front. In this case, you can hide the
top of the screw by using the hole towards the top not
marked with a red "%".
For details see "4.6.4 Adjusting the Angle (pg. 69)".
Top side of plasma display
Notes
• If you plan to install speakers and cables, please
install them at this stage.
Do not connect the cables to the other device.
• For the speaker installation method, refer to the
speaker installation procedure in the plasma display
operating instructions or the under speaker operating
instructions.
• To install the under speaker in particular, first attach
hang the plasma display on the wall with only the
speaker installation hardware and the speaker cord
attached, then attach the under speaker. Refer to
the under speaker operating instructions for the
method of attaching the speaker installation
hardware and the speaker cord.
PDP side hardware
Tilt Mount Unit: PDK-5011
5 Attach the wall side hardware to the wall.
Install the wall side hardware (4 locations) symmetri-
cally on the left and right side (one at each location
from the center of the
and bolts used to do this are different according to the
wall strength and wall material, purchase suitable
screws and bolts separately.
Note
Check the strength of the wall and beams before in-
stalling the display.
6 Attach the hook on the PDP side hardware to the wall
side hardware.
Note
Do not hold the speakers during the installation work.
Hook
Opening
Closing
Always have at least 2 people do this task.
Always make sure that the hook has been
Caution
hung.
). Because the screws
67