Installation On The Plasma Display - Pioneer PDP-425CMX Technical Manual

Speaker System: PDP-S44-LR

4.10.3 Installation on the plasma display

1) Installing procedure
Perform installation according to the following steps (1)
to (4).
Notes
• After this unit has been installed on the plasma dis-
play, you can't use the display operation panel. Please
use the remote control supplied with the display.
• The speakers are designed specifically for the left
(L) and right (R) sides.When mounting them on the
display, refer to the letters ("L" and "R") indicated
on the speakers' hooks.
• This speaker is of an antimagnetic design; however,
depending on its placement, for example, bringing
the speaker into the vicinity of a monitor other than
a plasma display, the speaker may cause irregular
color or other effects. Should this occur, please move
the speaker away from the display.
(1) Attach the cushions to the sides of the speakers in the
positions indicated on the diagram.
(2) Partially tighten the included screws (M8) in the screw
holes on the top of the display.
Screws (M8)
92
(3) Catch the hooks on the top of the speakers to the
partially tightened screws, then line up the holes in
the hooks on the bottom of the speakers with the
screw holes on the bottom of the display and partially
tighten the included screws (M8) in them.
Screws (M8)
(4) Fully tighten the four partially tightened screws.
* Push the speaker against the display while driving
the screw.
Cushions
When the speakers are installed on the display, do not
move the unit by lifting up the speakers.
The display could fall and cause injury.
WARNING