Calculating Heat Quantity; Product Mounting Holes - Pioneer PDP-425CMX Technical Manual

3.2.2 Calculating heat quantity

As a curtesy to our customers, we have included the power formula to calculate the air conditioning needs.
For power consumption, allow for 320 W = 320 VA per unit.
Since most of the power consumed is transformed into heat, power consumption may be regarded as roughly equal to
generated heat.
1 Conversion to calories
[W] × 0.86 = [kcal/h]
Heat generated per display: 320 W × 0.86 = 275 kcal/h
2 Conversion to British Thermal Units
[W] × 3.41 = [BTU/h]
Heat generated per unit: 320 W × 3.41 = 1019 BTU/h

3.2.3 Product mounting holes

We recommend using mounting hardware available from Pioneer. If you use other mounting hardware items, mount
them to the unit using the M8-bolt holes provided in the unit. Tighten the bolts with a torque between 50 kg/cm and 80
kg/cm. Applying a torque beyond these limits may lead to internal component failure.
• Locations of useable mount holes are shown below.
b hole
a holes
b hole
Rear view diagram
Always use a minimum of 4 mounting holes, evenly distributed on opposite sides of both the horizontal and
vertical center lines.
Use bolts that can be driven 12 mm to 18 mm into holes "a" and from 12 mm to 14 mm into holes "b" as shown
in the Side View above.
Do not block or cover air outlets and openings for ventilation on the rear panel.
Take precautions to prevent soiling walls behind the product with exhaust air discharged from the air outlets.
This unit incorporates glass components. Install only on flat surfaces.
Always turn every bolt by hand 2 or 3 times and check to make sure it is straight, then tighten it using a tool.
Do not over tighten bolts.
Do not use loctight or similar bonding products.
Please make sure that you use M4 (P=0.7) or M8 (P=1.25) bolts (other types of bolt cannot be used).
Vent (fan)
Center line
a Holes (6 places)
b Holes (4 places)
b hole
a holes
b hole
12 mm to 18 mm
Installation Conditions
Attaching
surface
Installation
This unit
bracket etc...
a hole
Bolt
12 mm to 18 mm
b hole
Bolt
Side view diagram
21