Pioneer PDP-425CMX Technical Manual page 13

Connection Panel
When installing PDA-5003
INPUT3
S-VIDEO
~
When installing PDA-5004
S-VIDEO
^
IN OUT
COMBINATION
1
Plasma Display Section
1
COMBINATION IN/OUT
Never connect any component to these
connectors without first consulting your Pioneer
installation technician.
These connectors are used for Plasma Display
setup adjustments.
2
RS-232C
Never connect any component to this connector
without first consulting your Pioneer installation
technician.
This connector is used for Plasma Display setup
adjustments.
3
AUDIO (OUTPUT) (Stereo mini jack)
Use to output the audio of the selected source
component connected to the Plasma Display to an
AV amplifier or similar component.
Note
No sound is produced from the AUDIO (OUTPUT) jack
when the MAIN POWER switch is set to OFF or ON
(standby).
4
AUDIO (INPUT1) (Stereo mini jack)
Use to obtain sound when INPUT1 is selected.
Connect this jack to the audio output connector of
the device connected to the Plasma Display's
INPUT1.
INPUT4 AUDIO
VIDEO INPUT 3/4
IN OUT R L G(ON SYNC) B
! @ #
INPUT3 INPUT4
AUDIO VIDEO
R L IN OUT R
& * ( )
RS-232C
2
9
INPUT5
ANALOG RGB AUDIO
R HD (H/V SYNC) VD R L
$ %
COMPONENT
INPUT5
AUDIO AUDIO
VIDEO
L Y Pb/Cb Pr/Cr R L
_ +
OUTPUT INPUT1 INPUT2
ANALOG RGB OUT
(D-Sub)
AUDIO AUDIO AUDIO
3 45 6
5
AUDIO (INPUT2) (Stereo mini jack)
Use to obtain sound when INPUT2 is selected.
Connect this jack to the audio output connector of
the device connected to the Plasma Display's
INPUT2.
6
ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use the ANALOG RGB OUT (INPUT1) connector to
output the video signal to an external monitor or
other component.
Note
The video signal will not be output from the ANALOG
RGB OUT (INPUT1) connector when the main power of
this display is off or in standby mode (page 10).
7
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connecting components equipped with RGB
outputs jacks, such as a personal computer or
external RGB decoder; or components equipped
with component output jacks, such as a DVD
recorder. Make sure that the connection made
corresponds to the format of the signal output from
the connected component.
8
DIGITAL RGB (INPUT2) (DVI-D jack)
Use to connect to a computer.
Use to connect to an AV component (HDCP
supported) equipped with DVI output connector.
Controls and Connectors
0 - =
INPUT1 INPUT2
ANALOG RGB IN DIGITAL RGB
(D-Sub) (DVI-D)
7 8
13