Auto Set Up Mode Setting - Pioneer PDP-425CMX Technical Manual

Menu Mode

15) Auto Set Up Mode Setting

This function automatically performs adjustment of the video when the power is turned ON, when input is changed,
and when the type of input signal is changed.
Factory setting: INACTIVE
1 Select 'OPTION'.
2 Place the cursor on 'AUTO SET UP MODE' and press the
[SET] button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
3 INACTIVE
ACTIVE 2
Notes
• This setting is only effective when a PC signal is input to INPUT1 or INPUT5.
• The automatically adjusted items are the items 1 to 3 below.
'SCREEN' Adjustment inside the menu: 1. 'POSITION'
• The adjustment items are the same as when the 'AUTO SET UP' button is pressed on the remote control, however,
precision may be a little inferior. This difference in precision is due to short processing time in the AUTO SET UP
MODE of the menu settings.
• It may not be possible to adjust an input signal well, such as when the signal has low brightness. I that case, set
the AUTO SET UP MODE to INACTIVE, and perform adjustment as explained in the following section, 'SCREEN,
CLOCK, PHASE'.
• When the AUTO SET UP MODE is set to ACTIVE, and manual adjustment is performed for the 'SCREEN' in the
menu mode, 'AUTO SET UP MODE: ACTIVE' is displayed.
This is to warn that even though adjustment is manual, when the input changes, or when the type of signal
changes on the outside, the AUTO SET UP MODE functions and the adjusted values will be written over.
128
Screen 2
2. 'CLOCK'
3. 'PHASE'
MENU
PICTURE SCREEN SETUP
L A N G U A G E
E N E R G Y S AV E
T I M E R S E T T I N G
S C R E E N M G T.
A U T O S E T U P M O D E
A U T O F U N C T I O N
P I P D E T E C T
S P L I T F R E E Z E
SET CHANGE
INPUT1
OPTION
: E N G L I S H
: S TA N D A R D
: I N A C T I V E
: O F F
: A C T I V E
: O F F
MENU EXIT