Hanging On The Wall - Pioneer PDP-425CMX Technical Manual

Special Instruction (Hanging on the wall)

3.4.2 Hanging on the wall

Carefully read the following before attempting to hang the unit on a wall, and observe the various limitations specified
below. Be sure to mount the unit so that twisting, bending, or any other deformation does not exceed 4 mm.
A
50
C
Operating temperature restrictions
✩ Standard single-unit installation
Distance from wall (A)
50 mm or less
50 mm or more
✩ Horizontal/vertical, left/right reverse installation (Note that only Examples 2 and 3 apply in cases
where top and bottom are reversed)
* No matter what the distance between the unit and the wall, the unit must be installed in such a way as
to ensure free air flow (With no obstructions within a distance of 300 mm from the unit).
Distance from wall (A)
50 mm or more
✩ Requirements when used with PDP-S44-LR speaker system
When installed as a single unit, all requirements are the same as those listed above for horizontal/
vertical, left/right reverse installation. Note, however, that the figures listed above are to be interpreted
as indicating the distance between the speakers and the wall.
Note
Different temperature restrictions apply to the PDK-5011 and PDK-WM01. Refer to "4.6 Tilt Mount Unit (pg. 64)" and
"4.7 Wall Mount Unit (pg. 72)". In wall-mounting installation, allow adequate space (a clearance of 300 mm or more)
above and below the monitor set, as well as to the right and left.
30
Shaded areas
: Thermometer (temperature measurement point)
D
B
300 mm or more 300 mm or more
100 mm or more 50 mm or more
B
300 mm or more 300 mm or more
indicate attachment points for mounting hardware.
1022
C D
300 mm or more
50 mm or more
C D
300 mm or more
D
Ambient temperature
0 °C to 35 °C
0 °C to 40 °C
Ambient temperature
0 °C to 35°C