Disassembling The Display Stand; How To Install; Display Stand; Rear Cover - Pioneer PDP-425CMX Technical Manual

Mobile Cart: PDK-5014

4.9.3 Disassembling the display stand

1 Remove the screws (four locations on the left and right
sides) and take off the bracket. For packing reasons,
the bracket is installed at a location that is different
from the location where it is usually installed when it
is used.

Bracket

Screws

4.9.4 How to install

In order to ensure safety during installation, always be sure to work together with more than two persons.
1 Assemble the unit
Attach the leg base to the display stand using the hexagonal bored bolts (M8 × 60) so that the rear label faces
towards the back casters as the figure.
Note
In order to ensure safe installation, always be sure to alternately tighten each bolt two times or more until they are
firmly fixed in place.
86
Screws
Label

Display stand

2 Remove the rear cover.

Rear cover

Leg base

Back casters
Support caster
Do not take out the screws.
Loosen the
finger screws.

Washer

Plate spring washer

Hexagonal bored bolts
(M8 × 60)