Edge Blending; Adjust The Overlapping Area Of The Images (Edge Blending) - Epson EB-Z10005U User Manual

Multi-Projection Function
b
Adjust the position of the projected image in the following order
(starting from the adjustments that have larger corrections).
(1) Projector's position (angle)
s "Installation Settings"
(2) Lens shift/Zoom
s "Adjusting the Position of the Projected Image (Lens shift)"
s "Adjusting the Zoom"
(3) Correct the four image corners
s "Quick Corner" p.62
(4) Correct the slight position misalignment that occurs when matching the
projected images.
s "Point Correction"
c
Set the Color Mode to Multi-Projection with the [Color Mode]
button.
a
• You can also set from Color Mode in Multi-Projection.
s Extended - Multi-Projection - Color Mode
• When projecting 3D images, set it to 3D Multi-Projection.
d
Adjusts the color tone for the whole screen as necessary.
"Color Uniformity"
s
p.30
p.37
p.65
p.122
p.183

Edge Blending

Follow the steps below to adjust the overlapping areas of the images.
(1) Fine tune the overlapping areas to make seamless screen.
s "Adjust the overlapping area of the images (Edge Blending)"
p.35
(2) Adjust the brightness difference for each projector lamp.
s "Correcting the brightness"
(3) Adjust the color balance of the projected images.
s "Fine-tuning the color balance"

Adjust the overlapping area of the images (Edge Blending)

You can fine tune the overlapping areas to make seamless screen.
a
Press the [Menu] button while projecting.
"Using the Configuration Menu"
s
b
Select Multi-Projection from Extended.
p.81
p.83
p.85
p.114
81