Epson EB-Z10005U User Manual page 123

List of Functions
Submenu
Display You can make settings related to the projector's display.
Menu Position: Select the position to display the menu on
the projected screen.
Message Position: Select the position to display the message
on the projected screen.
Messages: When set to Off, the following items will not be
displayed.
Item names when the Source, Color Mode, or Aspect is
changed, messages when no signal is being input, and
warnings such as High Temp Warning.
Display Background
to Black, Blue, or Logo when no image signal is available.
Startup Screen
you turn on the projector.
Standby Confirmation: (This item can be set when the
Remote Control Type is set to Simple.) When set to On
(default), a confirmation message is displayed asking
whether or not to turn off the power when the [t] button
is pressed. Press the [t] button again to turn the power
off.
If it is set to Off, you can turn off the power simply by
pressing the [t] button once.
Air Filter Notice: Set whether or not to enable the Air
Filter Notice function. When this is set to On and a clog in
the air filter is detected, the message is displayed on the
screen.
Screen: (This item cannot be set when projecting images
from a computer over a network.) Set the aspect ratio and
position of the projected screen according to the screen
being used.
s "Screen Settings"
Panel Alignment: Correct color misalignments (red and
blue) in the screen.
s "Panel Alignment"
Color Uniformity: Adjusts the color tone balance for the
whole screen.
Function
* : You can set the screen background
*
: Set to On to display the User's Logo when
p.32
p.181
Submenu
s "Color Uniformity"
User's Logo * Change the User's Logo to display when the power is turned
on or the image signal is not input.
s "Saving a User's Logo"
Select from one of the following projection methods
Projection
depending on how the projector is installed.
Front, Front/Upside Down, Rear, and Rear/Upside Down
s "Changing the direction of the image (Projection)"
p.31
Set this parameter according to the installation angle of the
Direction
projector.
s "Installation Settings"
123
Function
p.183
p.96
p.30