Displaying The Web Control Screen; Using The Using Mail Notification To Report Problems - Epson EB-Z10005U User Manual

Monitoring and Controlling
Items that can only be set with a web browser
• SNMP Community Name (up to 32 single-byte alphanumeric characters)
• Monitor Password (up to 16 single-byte alphanumeric characters)
• HTTP port
Add the port used for Web control. However, the following ports
cannot be added.
80 (default), 843, 3620, 3621, 3625, 3629, 4352, 4649, 5357, 10000,
10001, 41794

Displaying the Web Control Screen

Use the following procedure to display the Web Control screen.
Make sure the computer and projector are connected to the network.
a
If your Web browser is set up to connect via a proxy server, the Web
Control screen cannot be displayed. To display Web control, you need
to make settings so that a proxy server is not used for a connection.
a
Start the Web browser on the computer.
b
Enter the IP address of the projector in the address input box of
the Web browser, and press the Enter key on the computer's
keyboard.
The Web Control screen is displayed.
When Web Control Password is set in the Network menu from the
projector's Configuration menu, the password entry screen is
displayed.
c
The user ID and password entry screen is displayed.
Enter "EPSONWEB" as the user ID.
The default password is "admin".
a
• Enter the user ID even if the password setting is disabled.
You cannot change the user ID.
• You can change the password in the Network menu in the
Configuration menu.
s Network - Basic - Web Control Password
Using the Using Mail Notification to Report
Problems
When you set the mail notification function, notification messages are sent
to the preset email addresses when a problem or warning occurs with a
projector. This allows operators to be notified of problems with projectors
even when they are at remote locations.
Network - Mail - Mail Notification
s
a
• Up to a maximum of three notification destinations (addresses) can
be registered, and notification messages can be sent to all three
destinations at once.
• If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
• If you set Standby Mode to Communication On, you can control
the projector even if it is in standby mode (when the power is
off).
s Extended - Standby Mode
187
p.129
p.127
p.122