Epson EB-Z10005U User Manual page 125

List of Functions
Submenu
• Lens Type: Select the model number for the lens you are
Operation
using. Select ELPLS04 for the projector that has a built-in
lens.
• Instant Off: When set to Enabled, the projector goes into
standby status in approximately three seconds after power
off. If you turn the power on immediately after turning it
off, command communication may be cut off. To stabilize
command communication, set this to Disabled. When set
to Disabled, the projector goes into standby status in
approximately 170 seconds after power off.
• Date & Time: Make system time settings for the
projector.
s "Setting the Time"
A/V Output: (Only available when Communication On is
A/V Settings
set for Standby Mode.) When set to Always On, you can
perform the following operations even if the projector is in
standby mode.
• Output images to an external monitor.
• Use the status monitor.
Monitor Out: Select the image source output to an external
monitor when the projector is in standby status. When set
to Auto, analog RGB signals from the Computer input port
or the BNC input port are output depending on which
source was selected when the projector was turned off.
Function
p.100
Submenu
Standby Mode (This item cannot be set when Extron XTP is set to On.)
If you set Communication On, you can perform the
following operations even if the projector is in standby
mode.
• Monitor and control the projector over a network.
• Output audio and images to an external device. (Only
when A/V Output is set to Always On.)
• Use the status monitor. (Only when A/V Output is set to
Always On.)
• Communication from the HDBaseT port is enabled. (Only
when Control Communications is set to On.)
• Start projection by inputting an image signal. (Only
available when Auto Power ON is set to On.)
a
When monitoring or controlling the pro‐
jector over the network using wireless LAN,
set Connection Mode to Advanced.
s Network - Wireless LAN - Connection
Mode
HDBaseT Control Communications (This cannot be set when Extron
XTP is set to On.) When set to On, Ethernet
communication, serial communication, and the wired
remote control through the HDBaseT Transmitter connected
to the HDBaseT port are all enabled. (When this is enabled,
the projector's LAN port, RS-232C port, and Remote port
are disabled.)
Extron XTP: Set to On when you connect the Extron XTP
transmitter or switcher to the HDBaseT port. See the
following Extron Web site for more details on the XTP
system.
http://www.extron.com/
a
When Extron XTP is set to On, the fan
may rotate in standby mode but this is not
abnormal.
125
Function
p.130