Epson EB-Z10005U User Manual page 144

Reading the Indicators
Indicator
Power Status Lamp1/
Lamp2
Off Blue - Off
Flashing
Off Blue - Orange -
Flashing On
Cause
Temp Filter
Cool System Error
Off
Orange -
Flashing
Lamp Error
Lamp Failure
Off Off
Remedy or Status
Stop using the projector, remove the power cord from the electrical outlet, and
contact your local dealer or the nearest address provided in the Epson Projector
Contact List.
Epson Projector Contact List
s
Check the following points.
• Remove the lamps and check if they are cracked.
s "Replacing the Lamp" p.175
• Clean the air filter.
s "Cleaning the Air Filter" p.172
If the lamps are not cracked: Attach the lamps again and turn on the power.
If the error continues: Replace the lamps with new ones and then turn on the
power.
If the error continues: Stop using the projector, remove the power cord from
the electrical outlet, and contact your local dealer or the nearest address
provided in the Epson Projector Contact List.
Epson Projector Contact List
s
If the lamp is cracked: Contact your local dealer or the addresses on the Epson
Projector Contact List for further advice. (If one of the lamps cracks, only the
other lamp is used. Replace the lamp as soon as you can.)
Epson Projector Contact List
s
When using at an altitude of 1,500 m or more, set High Altitude Mode to On.
s Extended - Operation - High Altitude Mode
Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down
when the projector is installed in a direction which is not horizontal.
s Extended - Direction p.122
Status Monitor Dis‐
play
Pump Error
Lamp1 Error (S)
Lamp1 Error (P)
Lamp2 Error (S)
Lamp2 Error (P)
Lamp1 Failure (S)
Lamp1 Failure (P)
Lamp2 Failure (S)
Lamp2 Failure (P)
p.122
144