Monogram ZIS48N Custom Options Manual And Installation Instructions page 44

• Place a handle standoff on each attachment post
Step 3:
along the handle. Position the screw hole on the
Install
Standoffs standoff to point to the floor.
onto Handles
• Install set screws into the bottom of each standoff,
using the Allen wrench provided. The standoff should
be tight against the handle.
Step 4: • Start mounting screws through the extrusion and just
Install
through the custom panel.
Handles
• Stand panels up on the hinge side and hold to
access the appearance side. Place handle against
mounting screws on the appearance side, drive top
screw from the back of the extrusion partially into the
standoff.
• Going down the handle, drive each screw partially
into the standoff, alternating back to the top until the
handle is tight against the door.
• Remove tape.
Step 5:
Install
Assembled
Panels
It is best that 2 people perform this step.
• Place panel/handle assembly onto the bottom trim
with support bracket tabs inserted into slots.
• Push and hold the panel back against the steel door
with door handle extrusion flush to the handle side of
the door.
• Reinstall original screws into the door extrusion.
• Open the door fully to stop.
44
ZKHTSS1 for 3/4" panels
Tubular Stainless Steel Handles
Screw
• Install screws at the top, and hinge side.
• Follow the same procedure on the opposite door.
Screw
Allen Wrench