Monogram ZIS48N Custom Options Manual And Installation Instructions page 34

Step 1
Temporarily
mount
door panels
• Place the prepared 3/4"custom door panels on the
• Push the panel back against the steel door, making
Step 2
Locate
position
of handles
• Determine the desired location of the custom handles
• Again, with both doors closed, check centerlines of
34
bottom trim with support bracket tabs inserted into
slots.
sure panel is flush with hinge side trim.
and carefully mark centerlines of the screw holes.
The handles must be located 3/4" to 1-1⁄2" from the
end of the extrusion.
the screw holes to be sure they are parallel to the
edge of the door, and level with opposite door.
ZKHT1 Trim Kit (For 3/4" Panels)
Support for Custom Handles
• Secure the panel to the trim temporarily by driving
2 screws through the back side of the trim at the top.
• Slide door extrusion in between panel and steel door.
Temporarily secure with 2 screws.
3/4" Min.
1-1/2" Max.
• Drill 1⁄16" pilot hole through the panel until it starts
into the aluminum extrusion. This will mark the
matching location for drilling a clearance hole when
assembling the extrusion, panel and handle.