Monogram ZIS48N Custom Options Manual And Installation Instructions page 36

Option 1 Installation
OPTION 2
For dispenser
model using
full-width
trim
Before
you
begin
All 3 custom door panels must be routed to accommo-
date the door extrusions. Route the panels as
illustrated, max. 1/4" deep, 1-13/16" wide, top to bottom
on the handle side.
Step 1
Locate position
of handle
Note:
be installed against the handle
bracket. The custom handle
cannot exceed 11-3/4" length.
• Position the handle bracket onto the steel door by
• Re-install dispenser trim, temporarily.
• Determine the desired location of the custom handle
36
Optimal final
Note:
appearance depends on careful
routing depth. Do not exceed
1⁄4" routing depth.
The custom handle must
matching existing screw holes on the door and
bracket.
and carefully mark centerlines of the screw holes.
ZKHT1 Trim Kit (For 3/4" Panels)
Support for Custom Handles
1-13/16"
1/4" Max.
Back Side
Handle Side Handle Side
Freezer Panel
Refer to installation instructions for ZKT48 trim kit,
Option 2.
• Follow Step No. 1 to remove standard aluminum trim.
• Follow Step No. 2 and 3 to attach new 3/4" trim pieces
and install panel support brackets.
Temporarily
Temporarily
Secure Secure
Handle Dispenser
Bracket
Trim
With
With
Screws Screws
• Drill 1⁄16" pilot hole through the trim until it starts
into the handle bracket. This marks the same location
onto the bracket.
• Remove dispenser trim and bracket.
1-13/16"
Back Side
Fresh Food Panel