Monogram ZIS48N Custom Options Manual And Installation Instructions page 28

• Open door to 90°.
OPTION 1
For non-dispenser • Remove the Phillips head screws from the full-length
model
or dispenser model
• Open the doors fully to stop.
using custom
• Remove the screws from the aluminum trim, top,
collar trim
• Retain screws. Discard original trim.
Step 1
Remove
handles & trim
Note:
be used, order ZWCD2 trim kit.
If a custom handle is to be used,
order ZKHT1 trim kit.
Step 2 • Attach the new 3/4" trim pieces on the top, hinge side
Install
3/4" trim
28
handles.
bottom and hinge side.
If a custom collar is to
Important:
trim piece is removed, an
aluminum shim secured to the
bottom of the door can be seen.
Do not attempt to remove this
piece.
and bottom using original screws.
ZKT48 Trim Kit
3/4" Custom Panels
When the bottom
48" Models