Monogram ZIS48N Custom Options Manual And Installation Instructions page 13

Custom Door Panel Dimensions
Using Trim Kit ZKT48
3/4" thick panel with custom handle
and/or ZWCD2 custom collar trim
Freezer Panel Freezer Panel
Standard Custom
Dispenser Dispenser
16 11/16"
37"
19 5/16" 19 5/16"
Important: Maximum weight for fresh food panels is
50 pounds and 30 pounds for freezer door panels.
Detail A
Upper
Freezer
Panel
1"
3/32"
1"
Freezer Door Face Freezer Door Face
Panel
Face
Lower
Freezer
Panel
Fresh Food
Panel
17 11/16"
67 15/16"
3 9/16"
27 5/16"
Detail B
Rout panels to specification below on
the handle side of each panel
1 13/16"
1/4"
Fresh Food Door Face
max
Detail C Custom
Dispenser Cutout
12 1/16"
12 5/16"
The Cutout is 12 1/16" wide
by 12 5/16" high. 3/4" panels
must be routed on all four
sides of the cutout. Rout
the back side of the panel
1/4" deep. 7/8" wide
(shaded area).
Custom Panel Dimensions
48" Built-In Refrigerator
ZISW48D (white dispenser)
ZISB48D (black dispenser)
• ZKT48 and ZKHT1 installed together provides for the
installation of 3/4" custom door and grille panels, using
a custom handle of your choice. Cut panels to size, rout
the handle side of the panels as shown below and install
(see detail B).
• For ZKHTSS1 tubular stainless steel handle kit, cut panels
to size and rout the handle side of the panels as shown in
detail B.
• For standard dispenser trim: Cut panels to size, rout the
handle side of the panels as shown in detail B, rout the
bottom of the upper freezer panel and the top of the lower
freezer panel to allow placement of support brackets (see
detail A) and install.
• For custom dispenser trim ZWCD2 kit must be used: Cut
panels to size, refer to detail C for dispenser cutout
routing instructions. When a raised panel design is used,
a custom middle rail is required. A 14-1/2" wide middle rail
must be used because the custom collar trim must be
located within the raised portion of the panel. This area
must be 3/4" thick. See detail D for raised panel design
requirements.
• When using the standard full-width dispenser trim, the
length of the custom handle, top to bottom cannot exceed
11-3/4". Locate the handle a minimum of 3/4" and a
maximum of 1-1/2" from the edge of the panel. There are
no length restrictions on handles for models using a
custom collar dispenser trim (ZWCD2).
A
1 13/16"
Grille Panel height can vary to fill installation
height.
Installation Height
Important: Maintain 1-1/2" min. gap between
top of doors and bottom of grille panel.
7/8"
Wide
Rout
Custom Grille Panel
47 1/2"
Over 1/4" Thick (3/4" max) Panel
Dimension A
83" 8-1/4"
83-1/2" 8-3/4"
84" 9-1/4"
84-1/2" 9-3/4"
Detail D
Raised Panel Design
A
Hole is Cut
After Door
Fabrication
14 1/2"
A
Wide
Middle
Rail
Handle
Side
13