Monogram ZIS48N Custom Options Manual And Installation Instructions page 43

Step 1:
• Open doors to 90°. Remove the screws from the full-
Remove
Handles
• Retain screws, discard handles.
Note: If a custom collar is to be used, order ZWCD1
Trim Kit for 36" and 42" wide models. Order ZWCD2 for
48" wide models.
Step 2:
• Cut a piece of corrugated to use as a pad to protect
Match
Handle Extrusions
to Panels
• Place custom panels on the pad, appearance side
Note: If panels are wood, be sure to note which end is
the top so that wood grain is in the correct direction
on both (or all 3) panels.
• Place new extrusion against the handle side of the
• Align the extrusion evenly with the top and bottom of
• Follow the same procedure on the opposite panel.
• Tape the extrusions to the panels to prevent
• Center punch and drill 1/8" pilot holes through the
• Turn panel over. On the appearance side, use 9/32" bit
IMPORTANT: Hole locations must be exact to accept handle
standoff and handle assembly.
For models with full width dispenser trim and 2 piece
freezer panels:
• Carefully, align the top of the upper panel and the
length handles of both doors.
the panel finish. Use 1/2" thick section of plywood to
protect flooring when drilling.
down.
panels.
the panel.
movement.
holes in the extrusion and into the panel.
to enlarge clearance hole.
bottom of the lower panel with extrusion ends.
ZKHTSS1 for 3/4" Panels
Tubulor Stainless Steel Handles
Top
End
Freezer
Upper
Panel
Back
Side
Back
Freezer
Side
Panel
Freezer
Lower
Panel
Models Freezer
With Full Width Extrusion
Dispenser Trim
Note: Be sure to orient
extrusions and handles
correctly. The top ends of
the extrusions are cutout to fit
the shape of the top of the
door.
Align Extrusion
Even With
Panel
Back
Side
Fresh
Food
Panel
Fresh Food
Extrusion
43