Monogram ZIS48N Custom Options Manual And Installation Instructions page 39

Step 2: • Cut a piece of corrugated to use as a pad to protect
Match
the panel finish. Use 1/2" thick section of plywood to
Handle Extrusions
protect flooring when drilling.
to Handle
• Place custom panels on the pad, appearance side
down.
Note: If panels are wood, be sure to note which end is
the top so that wood grain is in the correct direction on
both (or all 3) panels.
FOR CUSTOM
• On the back side of the panel – at the handle side,
WOOD
measure and mark 1/4" below the top edge of the
PANELS
panel with a pencil.
• Slip panels into new extrusion on the handle side of
See Step 2A
the panels.
for Stainless
• Align the extrusion at the pencil mark, 1/4" below the
Steel panels
top of the panel.
• Follow the same procedure on the opposite panel.
• Tape the extrusions to the panels to prevent move-
ment.
• Center punch and drill 1/8" pilot holes through the
holes in the extrusion and into the panel.
• Turn panel over. On the appearance side, use 9/32" bit
to enlarge clearance hole.
IMPORTANT: Hole locations must be exact to accept handle
standoff and handle assembly.
For models with full width dispenser trim and 2 piece
freezer panels:
• Measure 1/4" from the top of the upper panel and 1/4"
from the bottom of the lower panel. Mark with pencil
on the back handle side.
• Align the extrusion on the pencil mark as shown, top
and bottom.
ZKHSS1 for 1/4" Panels
Tubular Stainless Steel Handles
Top
End
Freezer
Upper
Panel
Back
Side
Back
Freezer
Side
Panel
Freezer
Lower
Panel
Models Freezer
With Full Width Extrusion
Dispenser Trim
Decorator
Door
Panel
Note: Be sure to orient
extrusions and handles
correctly. The top ends of the
extrusions are cutout to fit the
shape of the top of the door.
Align Extrusion
1/4" Below Top
of Panel
Back
Side
Fresh
Food
Panel
Fresh Food
Extrusion
Extrusion
39