Monogram ZIS48N Custom Options Manual And Installation Instructions page 11

Custom Door Panel Dimensions Using Standard Trim
1/4" thick panels
Panels secured to 1/4" thick backing
Freezer Panel Freezer Panel
Standard Custom
Dispenser Dispenser
16 5/8"
36 7/8"
19 1/4
19 1/4"
Important: Maximum weight for fresh food panels is
50 pounds and 30 pounds for freezer door panels.
Raised Panel on 1/4" Thick Backing
Using Standard Handles
1/4"
Appearance
Thick
Panel
Backing
1 1/4"
Clearance
hinge side
Case Trim
or
Fresh Food
Panel
17 11/16"
67 7/8"
3 9/16"
27 1/4"
2" Clearance
handle side
Door
Handle
Custom Panel Dimensions
48" Built-In Refrigerator
ZISW48D (white dispenser)
ZISB48D (black dispenser)
Standard Trim with 1/4" Panels
• 1/4" Panels: Cut panels to size.
• Custom handles with 1/4" door panels require Trim Kit
ZKH1. When using ZKH1 with the standard dispenser
trim, the length of the custom handle, top to bottom
cannot exceed 11-3/4".
• Tubular stainless steel handle kit, ZKHSS1.
• Custom collar dispenser trim with 1/4" door panels
require trim kit ZWCD2.
Standard Trim with Panels secured to
1/4" thick backing
• Applying a raised panel design to a 1/4" thick backing
(screwed or glued): Cut 1/4" panels to size, fabricate
the raised panel to permit clearances of at least 2"
from the handle side for fingertip clearance of the
standard handle, 1-1/4" from the hinge side to avoid
striking adjacent cabinetry and 5/16" from the top and
bottom edges to allow for the trim flange, then install.
• Countertops adjacent to refrigerator installation
should be mitered 45° degrees.
Note: ZWCD2 custom collar dispenser trim and
ZKHT1 custom handle kits cannot be used in this
configuration.
Custom Grille Panel
9" 1/4" Thick Panel
The grille panel frame is factory assembled
for 84" installation height. If installation height
varies, order ZG2 trim kit for optional side trim
pieces. Cut grille panel to sizes shown below.
Installation Height
83"
83-1/2"
84-1/2"
Important: Maintain 1-1/2" min. gap between
top of doors and bottom of panel frame.
Custom Dispenser Cutout
12 1/16"
12 5/16"
The Cutout is 12 1/16" wide
by 12 5/16" high.
47"
Panel Height
8"
8-1/2"
9-1/2"
11