Table of Contents
Advertisement
Pre-delivery service
1 Charge the battery for 4 hours at max. 3 amp.
2 Fit steering wheel, seat and any optional
equipment.
3 Check and adjust tyre pressure. (60 kPa, 0.6 bar,
9 psi).
4 Adjust cutting unit:
Adjust lift springs (effective weight of cutting unit
should be 12-15kg / 26.5-33 lb).
Adjust cutting unit so that rear edge is about 2-4
mm / 1/8" higher than front edge.
Adjust the cutting unit's cutting height setting so
that the connection rod is tensed at the lowest
cutting height.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission's oil
tank.
7 Connect battery.
8 Fill with fuel and start engine.
9 Check that machine does not move in neutral.
10 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lif lever safety switch.
The safety switch for the hydrostat pedals.
11 Check the engine speed See the Technical data
section.
12 Check the synchronisation between the front and
rear wheels. (Only 4x4-machines) See the
workshop manual.
Service journal
13 Tell customer about:
Needs and benefits of following the service
schedule.
Servicing and the influence of this journal on the
second-hand value of the machine.
Range of applications for Mulching.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding problems.
Certified:
_______________________________________________
Date, mileage, stamp, signature
After the first 8 hours
1 Change engine oil
2 Change the oil in the gearbox. (Only 4x4-
machines)
3 Check the synchronisation between the front and
rear wheels. (Only 4x4-machines)
– 5
English
Advertisement
Table of Contents
